Short answer

A replica IW329160 is a copy of the IWC Aquatimer Automatic 42, a steel dive watch with a 42 mm case and a 300 m depth rating. Listings run from about $180 to $450. The Aquatimer is a small slice of the replica market. Far fewer factories build it than the Portugieser or the Big Pilot, so the average copy carries more faults. Treat it as a visual copy. Do not dive with it.

The reference number

IWC catalogues the Aquatimer Automatic 42 in the IW3291 block. Published codes include IW329101 in steel with a black dial. IW329160 does not appear in IWC's public catalogue as far as we can check. Sellers use it as a stock code for the same 42 mm case. Match the watch to photos of the real model, not to the number.

Genuine specs to compare against

  • Case: steel, 42 mm wide, 14.1 mm thick
  • Water resistance: 30 bar (300 m)
  • Crystal: sapphire
  • Movement: calibre 30120, automatic, 42 h power reserve
  • Bezel: internal ring driven by the outer bezel (SafeDive)
  • Strap: steel bracelet or rubber

What the better copies get right

Case size and dial layout are close. The 42 mm footprint and the marker positions land in the right place. Rubber straps on mid-range copies hold up. Bracelet copies show the correct link shape and taper.

Where copies fail

  • Bezel: the inner ring moves with slack and does not track the outer ring. The SafeDive linkage is the hard part to copy.
  • Depth rating: copies hold 3 to 5 bar at best. Gaskets and crown seals are the weak point.
  • Crown: threads feel rough. Cross-threading after a few months is a common report.
  • Lume: short charge and fast fade. The real dial uses Super-LumiNova with a longer glow.
  • Movement: most copies use a Miyota 9015 or a 2824 clone. Neither is calibre 30120. Rotor noise is audible.
  • Caseback: shallow laser etching. Real engraving has deeper cuts and sharp edges.

Checks before you pay

  1. Ask for a video of a full bezel rotation. Slack over 1 mm at the marker is a reject.
  2. Ask for a movement photo. A Miyota 9015 shows a distinct rotor shape. A 2824 clone has a different bridge layout.
  3. Ask for a timegrapher shot. Rate inside plus or minus 15 s/day and amplitude above 250 degrees is acceptable at this price.
  4. Compare caseback text to photos of the real watch. Text errors are the fastest tell.
  5. Confirm lug width in writing. Strap fit is the first thing to fail.

Price bands

$180 to $250 buys a Miyota-powered copy with a rough bezel. $280 to $380 buys better case finishing and cleaner dial print. Above $400 the gain is small. No copy at any price matches the 300 m rating.

Limits

The watch is a look-alike. It has no service network, no parts supply once the run ends, and no valid depth rating. Resale value is near zero. Buy it for the Aquatimer shape on the wrist and accept those terms.