Short answer
A replica IW329148 is a copy of the IWC Aquatimer Automatic 42. Factory output runs from about $180 to $600. No copy carries the 300 m water rating of the original. Judge the watch on case size, inner bezel action, and dial print. Ignore the factory name.
The reference
IWC files the IW3291 family as the Aquatimer Automatic, 42 mm. Steel case, inner rotating dive bezel, sapphire crystal, screw-down crown, rated to 300 m. The IW329148 is one dial and strap variant inside that family. Check the current IWC catalog for the dial color and strap type before you compare a copy, because sellers mix parts from several variants.
Case and bezel checks
- Width: 42 mm. A copy that measures 44 mm is the wrong watch.
- Thickness: about 14.9 mm on the original. Calipers settle this in seconds.
- Bezel: turns under the crown at 2 o'clock. Action should be firm, with no play and no grinding.
- Dial: applied markers, clean print, lume that charges under a lamp and fades in 4 to 6 hours.
- Caseback: deep engraving. Laser etching looks flat under a loupe.
- Strap: quick-release pins on the original. Gaps at the lugs show on the wrist.
Movement
Most copies ship with a Miyota 9015 or a Chinese clone of an ETA 2824. IWC has used caliber 30120 with a 42-hour reserve and, in later production, caliber 32111 with a 120-hour reserve. A replica matches neither figure. Ask for the movement name and a photo of the rotor. This reference has a solid caseback, so finishing matters less than rate and amplitude. A watchmaker can read both on a timing machine in under a minute.
Water resistance
Cases use gaskets that are not tested to ISO 6425 or to the IWC rating. A $300 copy may survive a sink. Do not swim with it. If you plan to wear it near water, have a watchmaker pressure test the case first and reseal it.
Price bands
$180 to $250: stamped clasp, mineral glass on some units, flat dial print. $300 to $450: sapphire, 9015 movement, usable bezel. $500 and up: better lume, closer case profile, sharper engraving. Above $700 the gains get small.
Before you pay
- Ask for dated photos of the actual unit, crown pulled.
- Confirm the case measures 42 mm.
- Confirm the bezel turns and the crown screws down.
- Ask about returns and customs seizure policy in writing.
Unknown: which factory built a given unit. Sellers use trade names and change them. Treat a factory name as a claim, not a spec.