A fake Planet Ocean Ultra Deep Orange is a replica of Omega's 45.5 mm titanium 6,000 m diver, built with orange dial accents, matching bezel details and an orange rubber strap. Top-tier replicas cost about $380 to $650 and copy the case shape, crown guards, helium escape valve and dial layout with decent accuracy. None of them ship with a real 6,000 m rating. Expect 30 m to 50 m of usable water resistance after a watchmaker pressure tests the case and greases the gaskets.
Before You Buy
- Know the real numbers: 45.5 mm across, roughly 18.1 mm thick, Grade 5 titanium, 6,000 m / 20,000 ft rating, sapphire crystal, ceramic bezel insert.
- Set a budget. Entry replicas sit near $150, mid-tier builds near $250, and the best titanium-case versions run $380 to $650.
- Confirm your wrist size. A 45.5 mm case that is 18 mm thick needs a wrist of about 7.25 inches or more to sit correctly.
- Decide now that this is a replica. Do not bring it to a dealer and do not resell it as genuine.
How to Inspect an Orange Ultra Deep Replica
- Measure the case with calipers and confirm the diameter lands between 45.4 mm and 45.7 mm.
- Measure thickness at the caseback and reject anything past 19 mm.
- Check the case metal. Titanium feels warm and light, steel feels cold and heavy. Ask the seller for the alloy grade.
- Study the orange tone in daylight. The insert should read as a deep burnt orange with a matte ceramic finish, not a glossy safety orange.
- Rotate the bezel through all 120 clicks and confirm the triangle lines up with 12 o'clock and has no back-play.
- Inspect the dial print with a loupe. Text should be crisp, level and free of bleeding around the marker rings.
- Charge the lume with a phone light for 30 seconds and compare brightness across every marker.
- Check the helium escape valve at 10 o'clock. It should sit flush and turn without grit.
- Confirm the crown screws down in three smooth turns and pulls to two distinct positions.
- Ask for a timegrapher photo. A clone movement should hold within plus or minus 10 seconds a day.
- Test the strap or bracelet fit. Endlinks should meet the case with no visible gap and no rattle.
- Book a pressure test at a local watchmaker before you swim with it.
Common Flaws to Reject
- Orange that leans yellow or neon compared to factory photos.
- A glossy insert instead of matte ceramic.
- Case thickness past 19 mm, which makes the watch sit like a hockey puck.
- Shallow caseback engraving on the Seamaster logo and wave pattern.
- Weak or uneven lume.
- Date font that is too wide, or a window with no bevel.
Wear and Care
Rinse the case in fresh water after contact with salt or chlorine, then dry it with a soft cloth. Replicas rely on thin gaskets. Have them greased and the case pressure tested every 12 to 18 months if you swim. Keep the watch away from hot showers and saunas, since heat degrades rubber seals. A service interval of three to five years is normal for a clone movement. If the rotor wobbles or the watch runs fast, stop wearing it and let a watchmaker look at it, because a cheap movement will grind itself apart once a bearing fails.
Picking a Seller
- Ask for dated QC photos of the exact watch, not stock images.
- Request a video of the bezel turning and the second hand sweeping.
- Pay with a method that allows a dispute.
- Confirm the return window in writing before payment.